|Main Power:||4kw||Hydraulic Power:||5.5kw|
|Steel Thickness:||0.4-0.6mm||Station:||7 Stations+4 Stations Of Side Rollers|
|Decoiler:||Manual||Machine Structure:||Guide Pillar|
|Machine Frame:||350H Beam Welding||Drive:||By Chain|
Metal Roof Forming Machine,
Arch Sheet Roll Forming Machine
Technical data of Cap ridge roll forming machine
1. This machine is PLC controlled automatic roll forming machine line.
2. Machine including: un-coiler, main body with press& cutting part, hydraulic station, control desk, out table.
|Roller material||ASTM1045 chrome plated surface with chrome|
|Roller station||7 stations+ 4 stations of side rollers|
|Shaft diameter||￠56mm material: SAE1045 with tempering|
|Machine structure||guide pillar|
|Machine frame||350H beam welding|
|Feeding mode||by manual|
|Material of blade and press mould||Cr12, 58-62 HRC hardness|
|Cutting system||hydraulic post cutting|
|Suitable material||Color steel, 0.4-0.6mm|
|Driven system||by chain|
|Voltage||460V, 50HZ, 3P|
|Machine include 3 units of out table|
|Machine include 3T manual un-coiler|
|Machine include film system|
Maintenance and safety
1. There should be an earth wire independently connected to the ground.
2. Keep cleans all the electric components. Clean them once a month.
3. Do not open the door of the electric box except for cleaning and adjustment.
4. While doing the monthly cleaning, check the insulation and connecting conditions of each electric component. Make sure there is no heat generation or oxidization.
5. The machine: 415V/50HZ, operating parts: AC24V, Please refer to electric principle drawing and table for maintenance.
6. Do not modify system parameter unless the operator is specialized in controlling system
7. Once the system does not work properly, please send for specialized technicians or electricians for maintenance.
Machine picture for your reference: