Main Power: | 4kw | Hydraulic Power: | 5.5kw |
---|---|---|---|
Steel Thickness: | 0.4-0.6mm | Station: | 7 Stations+4 Stations Of Side Rollers |
Decoiler: | Manual | Machine Structure: | Wire Electrode Cutting |
Machine Frame: | 350H Beam Welding | Drive: | By Chain |
Highlight: | 4m/Min Ridge Cap Roll Forming machine,Cap Roll Forming Equipment 4kw,0.6mm Cap Roll Forming Equipment |
Technical data of Cap ridge roll forming machine
Cap ridge forming machine to make ridge cap suitable for steel roofing sheet top.Your ridge can be designed here.
Here are some popular ridge machines for your reference, stop to cut machine, working speed about 2-4m/min.
standard ridge with flat leg, which need to cut the leg according to roofing trapezoidal sheets during installing/
special ridge cutted according to roofing trapezoidal sheets, which can easily attached on roofing without futher cut during installing, which improve work efficiency greatly, and make great match to roofing sheets to water proof.
Saibo ridge cap forming machines include 3 ton manual decoiler, forming machine with post cut, PLC controller , hydraulic station, run out table. Mitsubishi or siemens control system allow you user friendly, you only put in the length and pieces , roll forming machine will automatically work.
1. Profile for reference
2. Specification of the material
No | Specification of the material | |
1
| Suitable Material | Colored Steel plate, Galvanized steel |
2
| Width of the raw material | According to the final product |
3 | Thickness | 0.4-0.7mm |
3. Machine Detailed Parameters
1 | Roller material | ASTM1045 chrome plated surface with chrome |
2 | Roller station | 7 stations+ 4 stations of side rollers |
3 | Shaft diameter | ¢65mm material: 40CR with tempering |
4 | Machine structure | Wire electrode cutting |
5 | Machine frame | 350H beam welding |
6 | Feeding mode | by manual |
7 | Main motor | 4kw |
8 | Hydraulic power | 5.5kw |
9 | Material of press mould | Cr12, 58-62 HRC hardness |
10 | Material of blade and press mould | Cr12, 58-62 HRC hardness |
11 | Cutting system | hydraulic post cutting |
12 | Suitable material | Color steel, 0.4-0.6mm |
13 | Driven system | by chain |
14 | Voltage | 380V, 50HZ, 3P |
4.Photos for reference
5. Maintenance and safety
1. There should be an earth wire independently connected to the ground.
2. Keep cleans all the electric components. Clean them once a month.
3. Do not open the door of the electric box except for cleaning and adjustment.
4. While doing the monthly cleaning, check the insulation and connecting conditions of each electric component. Make sure there is no heat generation or oxidization.
5. The machine: 380V/50HZ, operating parts: AC24V, Please refer to electric principle drawing and table for maintenance.
6. Do not modify system parameter unless the operator is specialized in controlling system
.
7. Once the system does not work properly, please send for specialized technicians or electricians for maintenance.
6.Machine picture for your reference: